2026 pricing
Pool Repair Cost in Sarasota
Every job we quote, with the range and the source behind it. Checked October 2026 against Florida contractor pricing and national cost data.
Pool repair in Sarasota runs from about $95–$175 for a diagnostic visit to $18,000 for a full resurface, with most single repairs landing between a few hundred and a couple of thousand dollars. The table below is every job we quote, with the range and where the range came from.
20 of the 23 rows are grounded in published Florida contractor pricing or national cost data checked in October 2026. The rest are marked trade-typical, which means we are telling you what this work normally costs rather than pointing at a source. We would rather label those than pretend.
| Job | Range | Where the figure comes from |
|---|---|---|
| Diagnostic visit | $95–$175 | Angi puts pool-pro labor at $75–$125 an hour nationally; there is no published Florida figure for a trip charge. Trade-typical, not sourced. |
| Leak detection: pressure, dye and listening | $275–$650 | Central Florida contractor $275–$450; Miami-Dade $250–$550; wider South Florida $200–$800. |
| Equipment-pad leak: o-ring, union, clamp band | $150–$450 | South Florida guide: pump seal, union, valve and filter o-ring leaks $150–$500. |
| Skimmer throat repair | $400–$1,200 | South Florida guide puts skimmer throat cracks at $150–$450 for the crack alone; the upper end here allows for deck work. |
| Underground plumbing repair | $400–$2,800 | Central Florida $400–$1,500; South Florida underground cracks $800–$2,800. |
| Pump: capacitor | $150–$300 | Pro labor figures of $100–$150 for a capacitor, plus the visit. |
| Pump: shaft seal and o-ring set | $200–$450 | Sits between the capacitor and the motor figures below. Trade-typical, not sourced. |
| Pump: motor replacement | $450–$900 | $250–$380 quoted for a 48-frame motor plus parts and the visit. |
| Pump: single-speed, supplied and installed | $700–$1,300 | Florida contractor: single-speed $700–$1,200 installed. |
| Pump: variable-speed, supplied and installed | $800–$2,500 | Florida contractor $800–$2,500 overall, variable-speed $1,200–$2,500; South Florida install labor $200–$500. |
| Heater: igniter, flame sensor or pressure switch | $250–$600 | Boca Raton contractor puts most heater repairs at $250–$1,800; this is the low band. |
| Heater: fan motor or contactor, heat pump | $350–$900 | National data: electric heat-pump repairs $200–$1,200. |
| Heater: descale the heat exchanger | $300–$700 | No published Florida figure; priced as a labor-led job. Trade-typical, not sourced. |
| Heater: typical repair, all causes | $250–$1,800 | Boca Raton contractor $250–$1,800; US average about $479 with a $166–$803 range. |
| Heater or heat pump, supplied and installed | $1,500–$5,500 | Florida contractor $1,500–$5,000; South Florida $1,800–$5,500. |
| Filter: cartridge element only | $120–$350 | Retail cartridge elements run about $85–$175 each, plus fitting. |
| Filter: full replacement, supplied and installed | $400–$2,800 | South Florida 2026 guide $400–$2,800 installed; HomeGuide $250–$1,700. |
| Pool light, LED, per fixture | $500–$1,500 | Angi 2026 puts LED replacement at $700–$1,500; HomeGuide $500–$1,700. |
| Salt cell replacement | $700–$1,800 | Professional replacement $700–$1,500; 2026 cell pricing $1,000–$1,800 by capacity. |
| Waterline tile, section or full run | $1,200–$6,000 | Published rates run $15–$60 per linear foot; a typical 80–100 ft waterline works out at roughly $1,200–$6,000. |
| Resurfacing: white plaster | $4,000–$9,000 | Florida basic plaster $4,000–$7,000; $3–$5 per sq ft installed. |
| Resurfacing: quartz | $7,000–$13,000 | Quartz $4.50–$9 per sq ft installed across Florida sources. |
| Resurfacing: pebble | $9,000–$18,000 | Pebble $6–$12 per sq ft; Central Florida premium finishes to about $18,000. |
These prices are estimates. They are here so you know roughly what you are dealing with before you call. The only number that counts is the written one you get after someone has looked at the pool, and that visit comes off the bill when we do the repair.
What actually moves the price
Four things, in order of how much they matter:
- What failed. A capacitor and a compressor are both “the heater is broken” and they are an order of magnitude apart.
- How hard it is to reach. Plumbing under a paver deck, a pad boxed in by a screen enclosure, or equipment on a condo roof all add hours before any repair starts.
- Age of the equipment. Older units often need adapters and re-plumbing rather than a like-for-like swap.
- Whether the pool has to come down. Draining is its own job here, because of the water table, and it is the main reason resurfacing sits where it does.
Where repair stops making sense
The trade rule of thumb is to replace once a repair passes roughly half of what new costs installed, and sooner on equipment in its mid-teens with a history of failures. We quote both sides when it is close, because on a ten-year-old single-speed pump the arithmetic often favors replacing even when the repair is technically possible.
What is not on this page
Weekly pool service, chemicals and cleaning. We do repairs only, so there is no maintenance contract to price and nothing here is a loss-leader for one.
Questions about cost
Why do you publish ranges instead of a price?
Because a pool repair price depends on what failed and how hard it is to reach, and anyone quoting a flat figure before looking is guessing. A range tells you whether to expect hundreds or thousands, which is the thing worth knowing before you call.
Is the diagnostic visit really credited?
Yes, when we do the repair. If you take the written quote elsewhere, the visit is what you paid for the diagnosis and the report.
Why is leak detection separate from leak repair?
They are different jobs. Detection is a few hours of testing with specific equipment and it sometimes ends with us telling you nothing is leaking. The repair is priced once we know what and where.
What makes a repair land at the top of its range?
Access, mostly. A pad tucked behind a screen enclosure, plumbing under a paver deck, equipment on a condo roof, or a pool that has to be partly drained all add hours. Older equipment that needs adapters rather than a like-for-like swap does too.
Do these figures include permits?
No. Most repairs need none. Equipment changes that alter the electrical supply, and structural shell work, can, we will tell you on the quote if a permit applies and what the fee is.
Get the number that actually applies to your pool
A range tells you the scale. A visit tells you the price. We come out, test what needs testing, and leave you with a written figure and no obligation to use it.
If the answer is that your pool does not need the repair you think it does, that is what you will be told.